4.4 System
This section provides detailed descriptions about all the settings classified under the [System] tab.
4.4.1 System Settings
This screen allows you to perform system settings on IP terminals.
4.4.1.1 System
Enable Multi Number
Description Specifies whether to enable or disable the multi number mode.
Value Range
• Yes
• No
Default Value No
Configuration File Reference MULTI_NUMBER_ENABLE (Page 201)
Enable Repeater Mode
Description Specifies whether to turn the repeater mode on or off.
Value Range
• Yes
• No
Default Value No
Configuration File Reference REPEATER_MODE (Page 320)
Enable SIP Trunk Service
Description Specifies whether you are using a SIP trunk service or not.
Document Version 2017-07 Administrator Guide 111
4.4.1 System Settings
To Next Page
Loading...
