Value Range
• Yes
• No
Default Value No
Configuration File Reference SIP_TRUNK_MODE_ENABLE (Page 202)
Enable Non-Registering SIP UA
Description Specifies whether to enable or disable SIP UA registration.
Note
• This setting is available only when [Enable SIP Trunk
Service] is set to [Yes].
Value Range
• Yes (Enable to work without registering SIP)
• No
Default Value No
Configuration File Reference SIP_NON_REGISTER_ENABLE (Page 202)
Send RTP on Call Hold
Description Specifies whether to enable or disable the continuous sending of RTP
packets while a call is on hold.
Note
• This setting is available only when [Enable SIP Trunk
Service] is set to [Yes].
Value Range
• Yes
• No
Default Value No
Configuration File Reference RTP_KEEP_ENABLE (Page 202)
4.4.2 Language Settings
This screen allows you to select the language used for the Web user interface. The language setting is only
applicable when you log in to the Web user interface as User.
Note
• If you change the language while logged in to the Web user interface with the User account, the
language will be changed after the message "Complete" is displayed. If you are logged in with the
Administrator account, the language will be changed when a user logs in to the Web user interface as
User.
• The language used for the Web user interface for the Administrator account is always English.
112 Administrator Guide Document Version 2017-07
4.4.2 Language Settings
To Next Page
Loading...
