235
Connecting with other devices
Storing on a Recorder
By connecting the camera to a Panasonic Blu-ray disc recorder or DVD recorder, you can
store the pictures and videos.
Getting started:
• Turn on the camera and recorder.
1
Connect the camera and recorder
• Check the direction of the terminals and plug in/out straight holding onto the plug. (Inserting
these at an angle may cause deformation or malfunction)
• Use the supplied USB connection cable or a commercially available Type-C USB connection
cable that complies with USB standards. (Depending on the country or area where the camera
was purchased, the USB connection cable may not be supplied with the camera.)
[USB/CHARGE] socket
USB connection cable
2
Operate the recorder to store the images.
●
Take care not to turn off the camera while storage is in progress.
●
Images such as 4K videos may not be supported depending on your recorder.
●
Turn off the camera and disconnect the USB connection cable before removing the card from the
camera. Otherwise, the recorded data may be damaged.
●
For the storage and playback procedures, refer to the operating instructions for the recorder.
To Next Page
Loading...
