466
16. Materials
Cannot record images.
The shutter will not operate immediately when the shutter button is
pressed.
• If [Focus/Release Priority] is set to [FOCUS], then recording will not take place until
focus is achieved. (336)
The recorded image is whitish.
• Images may look whitish when the lens or image sensor gets dirty with fingerprints
or similar.
If the lens is dirty, turn the camera off, then wipe the lens surface with a soft, dry
cloth.
For information about how to clean the image sensor, refer to page 477.
The recorded image is too bright or dark.
• Ensure AE Lock is not set where it is not appropriate. (212)
Multiple images are recorded at once.
• When drive mode is set to [ ] (Burst), pressing and holding the shutter button
will take burst pictures. (159)
• When [Bracket] is set, then pressing the shutter button records multiple images
while automatically changing the settings. (197)
The subject is not focused properly.
• Confirm the following details:
– Is the subject outside of the focus range?
– Is [Shutter AF] set to [OFF]? (333)
– Is [Focus/Release Priority] set to [RELEASE]? (336)
– Is AF Lock (212) set where it is not appropriate?
The recorded image is blurred.
The image stabilizer is not effective.
• The shutter speed will become slower and the image stabilizer function may not
work properly when recording in dark places.
In these cases, use a tripod and the self-timer when recording.
To Next Page
Loading...
