123
5. 6K/4K Photo and Drive Settings
Selecting pictures from 6K/4K burst file and
saving
This section describes how to select pictures from a 6K/4K burst file and save them.
For information on how to record 6K/4K burst files, refer to P116.
1 Select an image with the [ ] or [ ] icon on the playback
screen, and press 3.
• You can also perform the same operation by touching the icon [ ] or
[].
• If the image was recorded with [6K/4K Pre-Burst], proceed to step
3.
3 Drag the frames to select the frame you want to save
as a picture.
• You can also perform the same operation by pressing 2/
1.
• Touch and hold [ ]/[ ] to continuously rewind/forward
frame-by-frame.
4 Touch [ ] or [ ] to save the picture.
• A confirmation screen will be displayed.
∫ Saving pictures taken with the 6K/4K Photo function at once ([6K/4K PHOTO Bulk
Saving])
You can save pictures of a 6K/4K burst file that were extracted from any 5 second period
at once.
1 Select the menu. (P55)
2 Press 2/1 to select the 6K/4K photo burst files and press [MENU/SET].
• If the burst time is 5 seconds or less, all frames will be saved as pictures.
3 Select the first frame of the pictures to be saved at once.
• Select the frame in the same way as you select pictures from a 6K/4K burst file.
• Pictures will be saved as a group of Burst Mode pictures in JPEG format. (P201)
2 Drag the slide bar to make a rough selection of
scenes.
• For information on how to use the slide view screen, refer to
P125.
• If the image was recorded with [6K/4K Burst] or [6K/4K
Burst(S/S)], you can select its scenes on the 6K/4K burst
playback screen by touching [ ] (Fn1). (P126)
Slide view screen
• The picture will be saved in JPEG format.
• The picture will be saved with recording information (Exif information), including its shutter
speed, aperture and ISO sensitivity information.
> [Playback] > [6K/4K PHOTO Bulk Saving]
Fn2
Fn1
MENU
To Next Page
Loading...
Need help?
General
