41
Recording
(ENG) DVQX1072
∫ Adding markers to select and save pictures ([6K/4K Burst(S/S)])
You can add markers if you press [Fn2] during recording. (Up to 40 markers per recording)
When selecting and saving pictures from a 6K/4K burst file, you can skip to the positions
where you added markers.
∫ Setting Pre-Burst Recording ([6K/4K Burst]/[6K/4K Burst(S/S)])
The camera starts recording approximately 1 second before the shutter button is pressed
fully, so you will not miss a photo opportunity.
• Auto Focus operation settings and menus that cannot be set while this function is in use are the
same as those during [6K/4K Pre-Burst] operation.
∫ Setting Loop Recording ([6K/4K Burst(S/S)])
With [6K/4K Burst(S/S)], you can perform recording while deleting the oldest recorded
data, allowing you to keep on recording while waiting for a photo opportunity without
replacing the card.
• Once you start recording, the 6K/4K burst file will be recorded and divided approximately every
2minutes.
Approximately the last 10 minutes (up to approximately 12 minutes) will be saved. The
preceding part will be deleted.
• [Loop Recording(4K PHOTO)] is not available for [6K 18M].
1 Select an image with the [ ] or [ ] icon on the playback
screen, and press 3.
• If the image was recorded with [6K/4K Pre-Burst], proceed to step 3.
2 Drag the slide bar to make a rough selection of
scenes.
3 Drag the frames to select the frame you want to save
as a picture.
• Touch and hold [ ]/[ ] to continuously rewind/forward
frame-by-frame.
4 Touch [ ] or [ ] to save the picture.
• A confirmation screen will be displayed.
• The picture will be saved in JPEG format.
> [Rec] > [6K/4K PHOTO] > [Pre-Burst Recording] > [ON]
> [Rec] > [6K/4K PHOTO] > [Loop Recording(4K PHOTO)] > [ON]
Selecting pictures from 6K/4K burst file and saving
MENU
DC-GH5BodyGN-DVQX1072_eng.book 41 ページ ２０１７年２月１３日 月曜日 午前１１時４５分
To Next Page
Loading...
