Others
71
(ENG) DVQX1123
• You may not be able to record for a short while after turning this unit on when using a
large capacity card.
• This phenomenon occurs when the camera is trying to record with highly accurate focus
at a reduced Auto Focus speed, and is not a malfunction.
• When the electronic shutter is used, the flash is not activated.
• When [Silent Mode] is set to [ON], the flash is not activated.
• Is the card inserted?
• Is this a folder or picture which was processed in the PC?
If it is, it cannot be played back by this unit.
> It is recommended to use the software “PHOTOfunSTUDIO” (P65) to write pictures
from PC to card.
• Has [Playback Mode] been set for playback?
> Change to [Normal Play].
∫ General tips for using a Wi-Fi connection
• Use within the communication range of the device to be connected.
• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz
frequency operated nearby?
> Radio waves may get interrupted when used simultaneously. Use them sufficiently
away from the device.
• When the battery indicator is flashing red, the connection with other equipment may not
start or the connection may be disrupted.
(A message such as [Communication error] is displayed.)
• If you place the camera on a metal table or shelf, the radio waves may be adversely
affected. In such cases, you may not be able to establish a connection. Move the
camera away from the metal surface.
Recording motion pictures is not possible.
Sometimes it is difficult to focus with Auto Focus when recording 4K
motion pictures.
The flash is not activated.
The picture is not played back.
There are no recorded pictures.
A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.
DC-GX800EB-DVQX1123_eng.book 71 ページ ２０１６年１２月１日 木曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
