Preparation
16
VQT0R26
Inserting/Removing the Card
• Check that the camera is turned off and
that the lens is retracted.
1 Slide the release lever to the
direction of arrow, and open the
card/battery door.
• The card and the data may be
damaged if it is inserted or removed
while the camera is turned on.
• We recommend using Panasonic’s
SD Memory Card. (Use only genuine
SD cards with an SD Logo.)
2 Insert:
Insert the card fully with the label
side facing the front of the
camera until it clicks.
Remove:
Push the card until it clicks, then
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals
on the back side of the card.
• The card may be damaged if it is not
fully inserted.
3 1 Close the card/battery door.
2 Slide the release lever to the
direction of arrow.
• If the card/battery door cannot be
completely closed, remove the card and
insert it again.
OPEN
LOCK
OPEN
LOCK
To Next Page
Loading...
