Playback (advanced)
95
VQT0Q09
Playing Back Pictures on a TV Screen
∫ Playing back pictures with the
supplied cable
The procedure for DMC-FZ5 is described
below. In the case of DMC-FZ4, connect
the TV and the [V.OUT] terminal on the
camera with the video cable (supplied).
• Turn the camera and the TV off.
1 Connect the AV cable A
(supplied) to the [AV OUT] socket
of the camera.
• Connect the AV cable with the [ ]
mark facing you.
• Hold the plug B to push into or pull out.
2 Connect the AV cable to the video
input and the audio input sockets
of the TV.
• 1 Yellow: to the video input socket
• 2 White: to the audio input socket
3 Turn the TV on and select external
input.
4 Turn the camera on and then set
the mode dial to playback mode
[].
∫ Viewing pictures in other countries
When setting [VIDEO OUT] on the
[SETUP] menu, you can view images on
the TV in other countries (regions) which
use the NTSC or PAL system.
• Even if you set menu selection for
[VIDEO OUT] to [PAL], the output signal is
still NTSC in the recording mode.
∫ Playback pictures on TV with SD
Memory Card slot
A recorded SD Memory Card can be
played back on TVs with an SD Memory
Card slot.
If you play back pictures recorded using
[HDTV] mode on a High-Definition TV,
(HDTV has 16:9 aspect) the picture quality
will be better.
(MultiMediaCard may not be played back
on TV with SD Memory Card slot.)
• Do not use any other AV cables
(DMC-FZ5)/video cables (DMC-FZ4)
except the supplied one.
• Read the TV operating instructions too.
• Audio playback is in monaural.
(DMC-FZ5 only)
DC IN 8.4V
AV OUT/
DIGITAL
VQT0Q09ENG.book 95 ページ ２００５年１月２５日 火曜日 午後８時１７分
To Next Page
Loading...
