Advanced (Recording pictures)
- 78 -
[REC] mode:
Setting the Light Sensitivity
This allows the sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
Press 1 ().
Press 3/4 to select the ISO sensitivity and then
press [MENU/SET] to set.
• You can also press 1 [ ] to select.
• You can also press the shutter button halfway to set.
• The menu screen disappears after about 5 seconds. At this
time, the selected item is automatically set.
¢ When the [ISO LIMIT SET] of [REC] mode menu (P127) is set to anything except
[AUTO], it is set automatically within the value set in [ISO LIMIT SET].
It is set as following when the [ISO LIMIT SET] is set to [AUTO].
• When [AUTO] is selected, ISO sensitivity is adjusted automatically depending on
brightness within a maximum setting of [ISO400]. ([ISO800] when the flash is used)
• When setting to [ ], ISO sensitivity will adjust automatically depending on brightness
within the maximum setting of [ISO1600]. ([ISO800] when the flash is used)
• ISO sensitivity will operate as [AUTO] in Motion Picture Recording other than Creative Motion
Picture. Also, [ISO LIMIT SET] will not function.
ISO sensitivity
80 1600
Recording location
(recommended)
When it is light (outdoors) When it is dark
Shutter speed Slow Fast
Noise Less Increased
ISO sensitivity
Settings
AUTO
¢
The ISO sensitivity is automatically adjusted according to the
brightness.
¢
(Intelligent)
The ISO sensitivity is adjusted according to the movement of
the subject and the brightness.
80/100/200/400/800/1600 The ISO sensitivity is fixed to various settings.
To Next Page
Loading...
