VQT2X28 (ENG)
14
∫ About the [CHARGE] indicator
•
When the [CHARGE] indicator flashes
–
The battery temperature is too high or too low. It is recommended to charge the
battery again in an ambient temperature of between 10
o
C to 30
o
C
(50
o
F to 86
o
F).
–
The terminals of the charger or the battery are dirty. In this case, wipe them with a dry cloth.
∫ Charging
∫ Recording still pictures (When using the LCD monitor/Viewfinder)
Recording conditions by CIPA standard
• CIPA is an abbreviation of [Camera & Imaging Products Association].
• Temperature: 23 oC (73.4 oF)/Humidity: 50%RH when LCD monitor is on.
• Using a Panasonic SD Memory Card (32 MB).
• Using the supplied battery.
• Starting recording 30 seconds after the camera is turned on. (When the Optical
Image Stabilizer Function is set to [AUTO].)
• Recording once every 30 seconds with full flash every second recording.
• Rotating the zoom lever from Tele to Wide or vice versa in every recording.
• Turning the camera off every 10 recordings and leaving it until the temperature
of the battery decreases.
∫ Playback (When using the LCD monitor/Viewfinder)
Connect the AC mains lead.
• Disconnect the charger from the
electrical socket and detach the battery
after charging is completed.
The [CHARGE]
indicator turns on:
The [CHARGE] indicator
A
is turned on and charging will start.
The [CHARGE]
indicator turns off: The [CHARGE] indicator A of the charger will turn off
once the charging has completed without any problem.
Charging time Approx. 155 min
Number of recordable
pictures
Approx. 580 pictures
(By CIPA standard in
Programme AE Mode)
Recording time Approx. 290 min
Playback time Approx. 540 min
DMC-FZ45&40_EB-VQT2X28_eng.book 14 ページ ２０１０年７月２日 金曜日 午後４時９分
To Next Page
Loading...
