Recording
- 72 -
Recording Mode:
Taking Pictures using the Built-in Flash
Note
•
Be careful not to catch a finger when closing a flash bulb.
Applicable modes:
Set the built-in flash to match the recording.
•
Open the flash.
1 Select [FLASH] in the [REC] Mode menu. (P56)
2 Press 3/4 to select a mode and press [MENU/SET].
•
Exit the menu after it is set.
A To open the flash
B To close the flash
• Be sure to close the flash when not in use.
• The flash setting is fixed to [Œ] while the flash
is closed.
Slide the flash open
lever.
Press the flash until
it clicks.
Switching to the appropriate flash setting
To Next Page
Loading...
