Playback/Editing
- 152 -
You can add text (comments) to pictures. After text has been registered, it can be stamped
in prints using [TEXT STAMP] (P153). (Only alphabetic characters and symbols can be
entered.)
1 Select [TITLE EDIT] on the [PLAYBACK] Mode menu. (P56)
2 Press 3/4 to select [SINGLE] or [MULTI] and then press [MENU/SET].
4 Enter the text. (P128)
•
Press [ ] to return to the menu screen. (The menu screen is automatically restored
when [MULTI] is selected.)
Note
•
To delete the title, erase all the text in the text input screen.
• Text can be scrolled if all of the registered text does not fit on the screen.
• You can print out texts (comments) using the “PHOTOfunSTUDIO 6.0 HD Edition” bundled
software on the CD-ROM (supplied).
• You can set up to 100 pictures at one time with [MULTI].
• You cannot use title edit for the following pictures.
– Motion pictures
– Pictures taken with [ ], [ ] or [ ]
– Pictures recorded with other equipment
[TITLE EDIT]
3 Select the picture, and then press
[MENU/SET] to set.
•
[’] is displayed for pictures with titles
already registered.
[MULTI] setting
Select the picture with 3/4/2/1 and
set (repeat) by pressing [MENU/SET],
then press
2 a few times to select [OK],
and execute by pressing [MENU/SET].
• The setting is cancelled when
[MENU/SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.
To Next Page
Loading...
