Preparation
- 16 -
Attach the lens cap.
Press the lens release button D while turning
the lens as far as possible in the direction of
the arrow to detach it.
• Always attach the body cap to the camera body so that dirt
or dust does not get inside.
• Attach the lens rear cap so that the lens contact point does
not get scratched.
Note
•
It is recommended to attach the lens cap or attach the MC Protector (optional) to protect the
lens surface when carrying. (P191)
In bright sunlight or backlight, the lens hood will minimise lens flare and ghosting. The lens
hood cuts off excess lighting and improves the picture quality.
To attach the lens hood (flower shape) that came with the interchangeable lens
(H-FS014042)
•
The interchangeable lens (H-H014) does not have a lens hood.
Insert the lens hood into the lens
with the short sides at the top and
bottom, and turn in the direction
of the arrow until it stops.
A Fitting to the mark.
Note
•
When temporarily detaching and carrying the lens hood, attach the lens
hood to the lens in the reverse direction.
Detaching a lens from the camera body
Attaching the Lens Hood
To Next Page
Loading...
Need help?
General
