51
2. Getting Started/Basic Operations
3 Press [MENU/SET] and set.
•
You can also complete this step by performing either of the operations below:
– Press the shutter button halfway
– Press [Fn13]
• Items that are temporarily assigned to the front/rear dials can be used only while the guide
(step
1) or setting screen (step 2) is displayed.
Setting the operation methods of the front dial and rear dial
> [Custom] > [Dial Set.]
[Assign Dial (F/SS)]
Assigns the operations of the aperture value and shutter speed
in Manual Exposure Mode.
[F SS]:
Assigns the aperture value to the front dial, and the shutter
speed to the rear dial.
[SS F]:
Assigns the shutter speed to the front dial, and the aperture
value to the rear dial.
[Rotation (F/SS)]
Changes the rotation direction of the dials for adjusting the
aperture value and shutter speed.
[]/[]
[Exp Comp Setup] (P167)
Allows you to expand the exposure compensation range with
the front or rear dial. (Only when the exposure compensation
dial is set to [j3] or [i3].)
[] (Front Dial)/[ ] (Rear Dial)/[OFF]
[Dial Operation Switch
Setup]
Sets the items to be assigned temporarily to the front/rear dials
when you press the function button to which [Dial Operation
Switch] is assigned.
[] ([Front Dial Operation])/[ ] ([Rear Dial Operation])
• Items that can be set are as follows.
– [Sensitivity] (P168)
– [White Balance] (P129)
– [Drive Mode] (P174)
– [AF Mode/MF] (P144)
– [Photo Style] (P123)
– [Filter Select] (P107, 125)
– [Aspect Ratio] (P133)
– [4K PHOTO] (P178)
– [Highlight Shadow] (P128)
– [i.Dynamic] (P136)
– [i.Resolution] (P136)
– [Flash Mode] (P229)
– [Flash Adjust.] (P232)
•
[Highlight Shadow] uses the two dials. It will be automatically
assigned to both of the dials when you assign it to either of them.
To Next Page
Loading...
Need help?
General
