Advanced-Shooting
Making the
LCD
monitor easier
to
see (LCD mode)
IIflJ
PAS
M
••
JRflgSCNOI
1 Press and hold [Q.MENU] until
quick setting screen is displayed.
2 Select indication at the right end
(initial setting:
[[~F])
using
~,
select mode using
~
and press
[MENU/SET].
...
®~
...
~
MENU
@@
42
.:.
'McX1e
.-
;
,';,;/
'
,,;U$es
'~
;-
-j.'.
~
Brightness of the LCD
AUTO
monitor automatically
POWER
LCD
changes depending
on brightness of the
environment.
[3
The LCD monitor becomes
POWER
brighter and easier to see
LCD
even when taking pictures
outdoors.
~O~
This
is
useful
~
HIGH
when you cannot
ANGLE
get close to the
subject because
there is a person
in
the way.
[~F
The LCD monitor returns to
the normal brightness.
• You can set LCD mode
in
setup menu.
(P21
)
• High angle mode
is
canceled if you
turn the camera off. (Same occurs
in
[POWER SAVE].)
• The LCD monitor automatically returns to
normal brightness after 30 seconds when
recording
in
power LCD mode. Press any
button to make the LCD monitor bright
again.
• The brightness of the pictures displayed
on the LCD monitor is adjusted when
power LCD mode or high angle mode
is activated. Therefore, some subjects
may look different on the LCD monitor.
However, this does not affect the
recorded pictures.
• If the screen is difficult to see because of
light from the sun etc. shining on
it,
use
your hand or another object to block the
light.
• The number of recordable pictures
decreases when the auto power LCD,
power LCD
or
high angle mode is used.
To Next Page
Loading...
