13
(ENG) VQT2M30
1:With the [LOCK] switch released, close the card/
battery door and terminal cover by pushing until you
hear a click.
• To prevent water seeping into the camera, be careful not to trap foreign
objects such as liquids, sand, hair or dust etc.
• Closing the door with the [LOCK] switch in the locked state may result in
damage or leaks.
2:Slide the [LOCK] switch in the direction of the arrow
until the visible red area is no longer visible and the
switch is locked.
• If you use the camera without securely closing the door and cover, it may
open and close of its own accord.
Note
•
If there is any foreign object, remove it
with attached brush.
• Sand and dust etc. will unintentionally
adhere to the camera by lodging in
between the gap around the card/
battery door or terminal cover when
used in the following locations:
–Where sand is floating, such as in the
sea or water etc.
–Where there is a lot of sand or dust,
such as at the beach or in a sand box
etc.
• To prevent unintentional opening of the card/battery door and terminal
cover, it is recommended to use the supplied silicon jacket.
N:
Red area
O: [LOCK] switch (gray part)
P: Released state
Q: Locked state
DMC-FT2&TS2P-VQT2M30_eng.book 13 ページ ２０１０年１月２９日 金曜日 午後５時３１分
To Next Page
Loading...
Need help?
General
