O_e_
Confirmation messages or error messages will be displayed on the screen in some cases.
The major messages are described below as examples.
Delete the picture after canceling the protect setting. (Plll)
• Pictures not based on the DCF standard cannot be deleted.
Format the card after saving necessary data on a PC etc. (P52)
• [Text Stamp] or [Print Set] cannot be set for pictures not based on the DCF standard.
• There is no space left on the built-in memory or the card.
• When you copy pictures from the built-in memory to the card (batch copy), the pictures are
copied until the capacity of the card becomes full.
• The following pictures cannot be copied.
-When a picture with the same name as the picture to be copied exists in the copy
destination. (Only when copying from a card to the built-in memory.)
- Files not based on the DCF standard.
• Moreover, pictures recorded or edited by other equipment may not be copied.
• This message will be displayed when you format the built-in memory on a PC.
Format the built-in memory on the camera again. (P52) The data on the built-in memory
will be deleted.
• It is a format that cannot be used with this unit.
Insert a different card and try again.
Reformat on this unit (P52/after saving necessary data using a PC, etc. Data will be
deleted.
• This message will be displayed when the lens did not operate properly.
Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Center.
- 138-
To Next Page
Loading...
