O_e_
Use a card compatible with this unit. (P22)
-SD Memory Card (8 MB to 2 GB)
-SDHC Memory Card (4 GB to 32 GB)
-SDXC Memory Card (48 GB, 64 GB)
• An error has occurred accessing the card.
Insert the card again.
Insert a different card.
• It has failed to read or write data.
Remove the card after turning the power off. Insert the card again, turn the power on, and
try to read or write the data again.
• The card may be broken.
Insert a different card.
• Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures.
• In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P52).
• Depending on the type of the card, motion picture recording may stop in the middle.
Format the card after saving necessary data on a PC etc. (P52)
Insert a different card,
• A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card after saving necessary data on a PC etc. (P52) If you execute [No.Reset]
in the [Setup] menu after formatting, the folder number is reset to 100. (P50)
• Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect. (P51)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (PI20,
123)
• Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• If the battery terminal is dirty, clean it and remove any objects.
• Refer to P20 for details.
- 139-
To Next Page
Loading...
