VQT2G33 (ENG)
14
Preparation
Setting Date/Time (Clock Set)
• The clock is not set when the camera is shipped.
Press [MENU/SET].
Press 2/1 to select the items (year, month,
day, hour, minute, display sequence or time
display format), and press 3/4 to set.
‚: Cancel without setting the clock.
Press [MENU/SET] to set.
• After completing the clock settings, turn the camera off. Then turn the camera back on,
switch to Recording Mode, and check that the display reflects the settings that were
performed.
• When [MENU/SET] has been pressed to complete the settings without the clock having
been set, set the clock correctly by following the
“Changing the clock setting” procedure
below.
Select [CLOCK SET] in the [REC] or [SETUP] menu, and press 1.
•
It can be changed in steps 3 and 4 to set the clock.
• The clock setting is maintained for 3 months using the built-in clock battery even
without the battery. (Leave the charged battery in the unit for 24 hours to charge the
built-in battery.)
Turn the camera on.
• The [PLEASE SET THE CLOCK] message appears.
(This message does not appear in [PLAYBACK]
Mode.)
A [MENU/SET] button
B Cursor buttons
Changing the clock setting
DMC-ZR1P-VQT2G33_eng.book 14 ページ ２００９年７月７日 火曜日 午後３時３３分
To Next Page
Loading...
Need help?
General
