96 VQT2R20 VQT2R20 97
For [REC] menu setting procedures (→20)
Using the [REC] menu (Continued)
[QUALITY]
Set quality of picture.
■
Recording Mode:
■
Settings: Fine (High quality, priority to picture quality)
Standard (Standard quality, priority to the number of pictures)
[ASPECT RATIO]
Aspect ratio of still picture can be changed according to printing or playback format.
■
Recording Mode:
■
Settings:
3
4
2
3
9
16
Same as 4:3 TV or computer Same as normal film camera For playback on widescreen/
high definition TV
●
Edges may be cut off when printing – be sure to check in advance.
●
In ([INTELLIGENT AUTO] Mode), (11.5M) and (10.5M) may be selected
by changing the [PICTURE SIZE].
[INTELLIGENT ISO]
Camera automatically adjusts ISO Sensitivity and shutter speed according to movement
of subject to avoid blur. Higher ISO Sensitivity reduces subject blur and jitter but can
increase interference. Please select maximum ISO Sensitivity according to table below.
■
Recording Mode:
■
Settings: [OFF] / / /
Setting guide
Movement of subject Slow Fast
ISO Sensitivity Low High
Shutter speed Slow Fast
Interference Low High
●
Slow-moving subject
●
Fast-moving subject
ISO Sensitivity 200
(Shutter speed 1/30)
ISO Sensitivity 800
(Shutter speed 1/125)
●
Shutter speed and ISO Sensitivity are displayed in the screen for a few seconds after
recording.
●
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
●
Blurring may occur depending on brightness, size, position, and speed of movement of
the subject (e.g. if subject is too small, is on edge of picture, or starts moving as soon
as shutter button is pressed).
●
Scope of flash recording (→48)
[SENSITIVITY]
Set ISO Sensitivity (sensitivity to lighting) manually.
We recommend higher settings to take clear pictures in darker locations.
■
Recording Mode:
■
Settings: [AUTO] / [80] / [100] / [200] / [400] / [800] / [1600]
Setting guide
[SENSITIVITY] [80] [1600]
Location
(recommended)
Bright
(outdoors)
Dark
Shutter speed Slow Fast
Interference Low High
●
[AUTO] is automatically set in a range up to 400 (1000 when flash is used) based on
subject movement and brightness.
●
Scope of flash recording (→48)
●
Cannot be set when [INTELLIGENT ISO] is used ( is displayed)
●
If interference becomes noticeable, we recommend reducing the setting, or setting
[NOISE REDUCTION] in [PICT.ADJ.] in the + direction.
To Next Page
Loading...
Need help?
General
