English
11
VQT5F44
Button Functions
[ SL AUTO] The flash can be fired remotely in sync with any
flash fired by other units.
[SL AUTO]: Flash level is set automatically.
[SL MANUAL]: The flash fires at the selected guide
number.
[ SL MANUAL]
[MULTI]
The flash can be fired many times in succession
while the shutter is open. (“Multi Flash Mode” (P12))
Button Function Use
[]
Adjust flash level by up to w5 EV.
This value is combined with
adjustments to flash
compensation made using the
camera.
1 Press [ ] (2) or [ZOOM]
(4).
2 Rotate the dial to select the
value, and then press the
[OK] button.
[ZOOM]
Adjust the lighting angle manually.
[M] appears in the display.
[]
Manually turn the LED light on or
off.
1 Before shooting, set the
LED light to [M].
“Other Settings” (P15)
2 Press [ ] (1) to turn the
LED light on. Press [ ] (1)
again to turn the LED light
off. To view the LED
brightness setting, press
and hold [ ] (1) for
2 seconds while the LED
light is on.
≥ The flash and batteries may
become warm if you keep the
LED light on, but this is not a
malfunction.
[
TEST/
CHARGE
]
To fire a test flash, press the [TEST/CHARGE] button while the [TEST/
CHARGE] lamp is lit.
[BACK
LIGHT]
The control panel backlight lights for about 15 seconds.
≥ If the flash is fired when the backlight is lit, it turns off.
To turn the backlight on again, press the [BACK LIGHT] button.
Control panel display Control operation
VQT5F44_JPN_PP_E.book 11 ページ ２０１４年４月１４日 月曜日 午後７時４１分
To Next Page
Loading...