Panasonic MC-CL934E - To Replace Dust Cup; Pre-Filter

- 12 -
TO REPLACE DUST CUP
➢ Place dust cup back into vacuum
cleaner by ➀ inserting the bottom first
and ➁ tilting back with the dust cup
handle raised.
➢ Lower the dust cup handle to lock dust
cup in place. A noticeable “click”
should be heard.
1
2
Pre-Filter
LOCKED
(For Use)
UNLOCKED
(For Cleaning)
Dust Cup
Lid Assembly
Pre-Filter
The pre-filter is located inside the dust
cup. Check the pre-filter frequently and
clean when dirty.
➢ Remove the dust cup. (see DUST
CUP, p. 11).
➢ Make sure the dust cup is empty.
➢ Rotate dust cup lid assembly
counterclockwise as indicated on the
lid and lift off.
➢ Grasp pre-filter and rotate
counterclockwise to remove.
➢ Clean pre-filter by gently tapping over
a trash container. Tap on several sides
to ensure best cleaning.
➢ If necessary, rinse with cold water
only, DO NOT use detergent or soap.
Allow parts to dry 24 hours before
putting back into vacuum cleaner.
➢ DO NOT wash in the dishwasher. DO
NOT install damp.