To prevent black mould and odour
Wash with 
chlorine-based  
bleach. 
(once a month)
Chlorine-
based bleach 
for clothes
(Approx. 
200 ml)
Note
 
Chlorine-based bleach for kitchen, oxygen-based bleach or detergent for 
kitchen may form excessive bubbles, causing water to drain in the middle 
of operation. Due to this, satisfactory result may not be achieved.
Select “Wash”.
(P.8)
Select 
“Tub Clean”.
 
Water is supplied.
 
After water supply 
fi nishes, press the Pause 
button. Directly put in into 
the drum.
 
Soak, Rinse and Spin
 
 
Approx. 11 hours will be taken. 
(Approx. 6 hours for “30 °C”)
When using 
warm water
Select “30 °C”.
Wash with water.
 
If the case is not cleaned, softener may not fl ow smoothly because of soil, or it will get mouldy.
1
Remove the case.
2
Remove the cover. Clean the tube of the 
case, back side of the cover and tube. 
(P.40)
When dirty
Wipe with a soft cloth.
 
If lint, water droplets or foreign objects have been attached 
on the back of the window seal, wipe them off  thoroughly. 
(This may cause water leak or smell.)
 
If dust such as lint is attached in the hole of the window 
seal, remove it.
For tough stains
 
Use a detergent for kitchen and wipe off .
Cover
Hold the 
protrusion, 
and pull it up.
 
Wipe off  the soil on the main unit side.
Wrung-
out towel, 
etc.
Window seal
Hole
When dirty