12
Installation
1. Check the location.
■
Avoid the following locations for installation.
•
Uneven or unstable locations
(on blocks, timbers, a table with wheels, etc.)
•
Locations with a possibility of freezing
2. Attach the bottom cover.
Preparation: Set a cardboard, etc. and lay the
washing machine on it, avoiding
product damage and deformation.
(Face the front side down.)
1
Insert the bottom cover along
the guides, and set 3
holes to
the corresponding
projections.
Projection
Hole
Guide
Hole
2
Fix with screws.
(6
locations for right, left and top)
Screw hole
3. Attach the external drain water hose.
1
Connect.
Insert all the way.
2
Slide the
hose band
in the arrow
direction.
● Slide all the way
until it stops.
Hose band
NOTE
● Do not put the
hose tip under
water.
● Do not raise the
hose higher than
10 cm above the
oor.
10 cm or
less
● Do not extend the
overall length to
more than 3 m.
3 m or less
Bottom cover
Water supply
hose
Water tap adaptor
Water
supply
valve
screw
External drain
water hose
Power
plug
To Next Page
Loading...
Need help?
General