Panasonic NC-HU301P

— 26 —
NC-HU301P, NC-HU401P
4.9. Upper trame
1. Remove cover
2. Remove water out pipe cover
3. Remove Container gasket
Point when assembling
• Set the dowel of Container comp. between 2 long ribs
(hinged side) of Dispensing spout comp. and assemble it.
• Setting of Container gasket shall be closely attached to the
flange of Container without twisting or distortion.
Fig-13
Fig-14
4.10. Name B (Display portion)
1. Remove A prizing open with the minus screwdriver
or pin.
Point when assembling
• Attach fixing the point A.
• To avoid the mist over of the Crystal liquid portion, press
perimeter especially the part of VIP thermo pot characters
strongly with fingers and stick it firmly.
Dispensing
comp.
Container gasket
Name B (Display portion)
A