EN12
English
Once every two or three months to clear scale.
How to clean with citric acid
1
Make sure that the mesh filter is attached to the inner container.
2
Put citric acid in the inner container.
z
Amount of citric acid to be used at one time:
80 g (two packages) or seven level tablespoons.
For citric acid, please contact an authorized service center (as described in the
warranty). (Model No: SAN-80N)
* Follow the directions for cleaning printed on the citric acid package.
* Since the citric acid used for cleaning is a food additive, it is harmless to humans.
3
Add water to the maximum water level mark,
and mix the citric acid and water well. Close the
lid.
4
Connect the power plug, and choose “Cleaning” by pressing .
Cleaning start End of cleaning
peep peep
peep peep
Flashing
simultaneously
Light off
Light off
Light on
It rotates during cleaning.
5
Dispense some water, then unplug, remove the lid and drain away the hot water via
the
DRAIN
mark. (õ. EN7)
6
Refill with water and boil it to remove the smell of the citric acid.
Then throw the hot water away in the same way as step 5.
z
To remove any discoloration from the area above the maximum water level, rub the inside lightly
with a wet soft sponge.
z
If the discoloration cannot be removed by rubbing, clean the inner container several times using citric acid.
z
When washed without removing ceramic filter, wash the ceramic filter under running water and fix
it in the inner container. Boil water and drain away.
Requests
z
Make sure only use citric acid for thermo pot washing.
z
Do not fill water above maximum water level.
z
Fill the inner container only with tap water (do not fill with hot water). Hot water may spout out
causing burns.
Citric acid
To Next Page
Loading...
