Panasonic NC-ZA1 - Page 40

EN40
Decalcificationcycle:
Use this cycle occasionally and/or when the display shows .
This decalcification cycle enables simple and effective descaling. This programme runs in 2 phases and it takes approximately
11 minutes and should not be interrupted. When display shows
, press and follow steps from 3.
1
Press onthemainmenu.
Note
• If the filter cartridge is set in the water tank, remove it before this
programme starts.
2
Select“descalingprogramme”.
Note
• If is pressed, the display will return to the previous display.
(First phase)
3
Fillthewatertankwith250mLofwaterandadd125mLofdescaling
agent,thenpress
.
Note
• If is pressed, the display will return to the previous display.
4
Press tostartdecalcificationcycle.(Approx.9min.)
• Empty the drip tray before starting the cleaning cycle.
Note
• If is pressed during descaling, the
display indicates to empty the drip tray. To
continue the descaling cycle, press
.
HowtoClean(Continued)