18.4. Replacement of upper antenna
1. Remove ceiling plate by gently moving the left and right
tabs inward while pulling the plate down and outward.
2. Using a small flat screwdriver or the like, remove two plastic
clips located on the antenna ring. Nest turn the antenna ring
approx. 1/8 turn clockwise to unhook the tabs and pull off.
18.5. Replacement of floor shelf and
lower antenna
1. To remove the floor shelf, insert a screwdriver through the
small opening on the left side of the oven cavity and
carefully lift the floor shelf.
2. For removal of lower antenna, use the same procedure as
upper antenna.
18.6. Replacement of temperature
sensor (Thermal protector)
1. Cut 2 lead wires at the top of sensor terminals.
28
NE-1257R/NE-1257CR / NE-1757R/NE-1757CR / NE-2157R/NE-2157CR / NE-1258R
To Next Page
Loading...
