– 30 –
Oven Lamp blinks at the end of heating cycle
To turn the blinking Oven Lamp ON at the end of heating cycle
5. Within 3 seconds after touching Prog Pad at Step 4, touch Start Pad.
“PROG” will start to blink. The previously set Oven Lamp blink settings are
displayed.
6. Touch Start Pad.
Note: “oFF”
“on” “oFF” is repeated each time the Pad is touched.
7. Touch Prog Pad.
“PROG” will stop blinking, and the Oven Lamp blink settings will appear for
3 seconds. Then “0” will appear.
To proceed to Step 8, touch Start Pad before “0” is displayed after Step 7.
Adjusting Oven Lamp brightness during cooking
To decrease brightness of the inner cavity during cooking
8. Within 3 seconds after touching Prog Pad at Step 7, touch Start Pad.
“PROG” will start to blink. The previously set Oven Lamp reduction settings are
displayed.
9. Touch Start Pad.
Note: “oFF”
“on” “oFF” is repeated each time the Pad is touched.
10. Touch Prog Pad.
“PROG” will stop blinking, and the Oven Lamp reduction settings will appear for
3 seconds. Then “0” will appear.
How to Operate NE-1853
To Next Page
Loading...
