1716
Be sure to disconnect the power plug from the power outlet
before lling the water resevoir with water.
How to fill water
1. Fill the cup up to the 70 mL
water level mark with distilled
or filtered water. (The water
resevoir capacity is about 70 mL.)
Open the water inlet cap, tilt
the main body slightly
(approx. 30°) as shown
in the figure, and then add
an appropriate amount of
water.
2. Close the water inlet
cap while the main
body is tilted. Pay attention
to the installation direction
of the water inlet cap.
Notes: a. Do not use tap water or high mineral content
of "mineral water". Otherwise, it will impact the
service life of product.
b. Please fill the water resevoir with distilled water
or pure water.
Notes:
a. When adding water to the water resevoir, tilt the main body
slightly (approx. 30°) and make sure that no water overows
from the water resevoir. Wipe water drops o the main body if
any.
b. Be sure to close the water inlet cap securely after adding water.
c. The water resevoir has a capacity of about 70 mL, with which
the product can be used continuously for about 4 minutes.
100ml
70ml
70ml
100ml
approx. 30°
approx. 30°
Using the steam iron
1. Insert the power plug into a suitable socket outlet.
The indicator will light on and the product will start
heating.
2. Wait about 20 seconds
and press the steam
button to use the product.
• Steam may not come
out immediately after
the product is powered
on. A sound may be heard.
This is normal.
• To add water during use, disconnect the power plug rst.
• Put the product on its side while
the product is heating up, or when
you are changing the garment
during use.
3. After use, disconnect the power plug to
cut o the power supply.
How to use
NI-GHD015 [i8200K-oS31A]_V1_说明书_EN,KR.indb 4NI-GHD015 [i8200K-oS31A]_V1_说明书_EN,KR.indb 4 2022/9/1 13:34:042022/9/1 13:34:04
To Next Page
Loading...