３． ＣＯＮＮＥＣＴＩＯＮ ＯＦ ＴＨＥ ＣＯＲＤ
Properly wire the AC power cord, the Indicator light cord and the complete control circuit cord
as shown in the figure.
Ｃｏｍ ｍｏｎ
ＷＡＲＮＩＮＧ
1. Please connect the wires exactly according to the circuit diagram when installing,
or it may lead to accidents of electrical leakage, smoke, injury etc.
2. During installing, all the screws must be fully fixed to avoid loosing and dropping,
which may result in injury and safety accidents because of the increasing current.
3. If new components need to be replaced, you must firstly check them from the
<ＲＥＰＬＡＣＥＭＥＮＴ ＰＡＲＴＳ ＬＩＳＴ>.
Make sure that they are the proper
components before installing.
4. Don't join the two pieces of the broken
cord of the components.
You must replace the broken components
with a whole replacement.
― 6 ―
To Next Page
Loading...
