Panasonic NI-JW670C

a) Lift the Indicator light assembly from the Heat-insulated
plate. Remove the screws indicated by arrows and
lift the Heat-insulated plate.
b) Lift the Packing(c). (NI-JW670C/JW660T only)
１．
ＩＮＳＴＡＬＬＡＴＩＯＮ ＯＦ ＨＥＡＴ‑ＩＮＳＵＬＡＴＥＤ ＰＬＡＴＥ
(ＡＴＴＡＣＨ ＴＨＥ ＨＡＮＤＬＥ)
Before installing the Heat-insulated plate, ought to turn
the Temperature selector dial in a clockwise direction
to the end of position.
７． ＲＥＭＯＶＡＬ ＯＦ ＨＥＡＴ‑ＩＮＳＵＬＡＴＥＤ ＰＬＡＴＥ
Remove the Fixed plate screws by arrows and lift the
Auto-valve assembly, then remove the Disc bimetal.
８． ＲＥＭＯＶＡＬ ＯＦ ＡＵＴＯ‑ＶＡＬＶＥ ＡＳＳＥＭＢＬＹ
ＤＩＲＥＣＴＩＯＮＳ ＦＯＲＲＥＡＳＳＥＭＢＬＹ
(ＲＥＡＳＳＥＭＢＬＹ ＩＮ ＴＨＥ ＯＲＤＥＲ ＲＥＶＥＲＳＥＳ
ＦＯＲ ＴＨＡＴ ＯＦ ＤＩＳＡＳＳＥＭＢＬＹ. ）
２．
ＩＮＳＴＡＬＬＡＴＩＯＮ ＯＦ ＴＥＭＰＥＲＡＴＵＲＥ
ＳＥＬＥＣＴＯＲ ＤＩＡＬ
Before installing the Temperature selector dial,ought to
turn the Temperature selector dial to maximum temperature
position then install it into Water tank.
Temperature adjustor
Heat-insulated plate
Indicator
light
Packing(C)
Auto-valve assembly
Soleplate
Thermostat stopper
Soleplate
Temperature selector dial
Turn the Temperature
selector dial to maximum
temperature position
Temperature dial
supporter
― 5 ―