Panasonic NN-8500

Controls and Operation Procedure
Clock Pad
When the plug is connected to an AC outlet the digital
display shows “88:88”.
To Set Clock
Step 1. Press the Clock Pad.
» The colon starts to blink.
Step 2. Enter the time by pressing the appropriate
Time Pads.
» The time is displayed on the digital display
and the colon blinks.
Example: To set 14:25,
press the Time Pads from left to
right as follows.
?
aLETY :
once 4 times twice 5 times
Step 3. Press the Clock Pad.
> The colon stops blinking and the time of day
is entered.
Notes on Clock
1. To reset the time of day repeat steps 1 through 3.
2. The time of day is displayed, unless the power
supply is interrupted.
3. Toclear the display “88:88”, press the Stop/Cancel
Pad.
4. This clock has a 24 hour display.
Stop/Cancel Pad
If the pad is pressed before cooking, all data input
are cancelled.
If the Stop/Cancel Pad is pressed once
during cooking, the cooking will be g
interrupted.
By pressing the Button twice during cooking all the
data input are cancelled and the time will be displayed
again.
Start Pad
By pressing the Start Pad the oven starts operating. If
during cooking the door is opened or the Stop/Cancel
Pad is pressed once, the Start Pad has to be
pressed again to continue cooking.
©
TIME Pads:
1. GRILL and all MICROWAVE Power levels.
10min imin 10sec 1sec
pad pad pad pad
Example: After selecting GRILL/MICROWAVE
Power to set 13 minutes 45 seconds.
2. COMBINATION, CONVECTION and Delay/Stand:
1 hour Inopera- 10 min 1 min
pad ble(ap- pad pad
pears as
“H” symbol
for hrs.
Example: After selecting CONVECTION temp,
COMBINATION program or DELAY/
STAND function set 2 hours 25 minutes.
Touch:
10 MIN Pad: once
1 MIN Pad: 3 times
10 SEC Pad: 4 times
1 SEC Pad: 5 times
Touch:
1 HOUR Pad: Twice
10 MIN Pad: Twice
1 MIN Pad: 5 times
Power Pad
Select power level before programming in the cooking
=
Beep sound
A beep sounds when a pad is pressed. If the beep
does not sound the button signal has not been entered
correctly. The beep signal sounds twice between
cooking stages, e.g. cooking and simmering, and
5 times at the end of the program.
Door Release button
The cooking is interrupted if the door is opened during
the cooking process, but the program is not cancelled.
Press the Start Pad again after closing the door to
continue cooking. When the door is opened the light
will turn on. ;