English
- Eng-38 -
Before Requesting Service (continued)
PROBLEM POSSIBLE CAUSE REMEDY
Oven will not turn on.
The oven is not plugged in
securely.
Remove plug from outlet, wait 10
seconds and re-insert.
Circuit Breaker or fuse is tripped
or blown.
Contact the specified service center.
There is a problem with the outlet.
Plug another appliance into the outlet
to check if the outlet is working.
Oven will not start
cooking.
The door is not closed completely. Close the oven door securely.
Start was not pressed after
programming.
Press dial to Start.
Another program has already been
entered into the oven.
Press Stop/Reset button to cancel
the previous program and program
again.
The program has not been entered
correctly.
Program again according to the
Operating Instructions.
Stop/Reset button has been
pressed accidentally.
Program oven again.
When the oven is turning
on, there is noise coming
from Glass Tray.
The roller ring and oven bottom
are dirty.
Clean these parts according to care
of your oven (See next page).
"H97" or "H98" appears in
the display window.
This display indicates a problem
with the microwave generation
system.
Contact the authorised service
center.
"DEMO MODE PRESS
ANY KEY" or "D" appears
in the display window.
The oven is under demonstration
mode.
Press Micro Power button once,
Start 4 times and Stop/Reset
button 4 times.
The "
" appears in the
display window.
The Child Lock was activated by
pressing Stop/Reset button 3 times.
Deactivate Lock by pressing
Stop/Reset button 3 times.
"HOT" appears in the
display window.
The cavity is overheated. Operate again after it cools down.
If it seems there is a problem with the oven, contact an authorized Service Center.
F0003CD50KP-O-I_part-0719.indd 38 2019/7/19 13:30:15
To Next Page
Loading...
