14. Carefully pull up base plate from front side, bent holding tab
as shown in figure.
15. Stand base plate by holding tabs
Warning: Any lead wire should not be caught by base.
16. Discharging high voltage by shorting high voltage terminal
to chassis ground.
WARNIG: Touch chassis side first.
17. Release 2 tabs to open air guide.
18. Inverter PCB
1. Release CN701/CN702/CN703 connectors
2. Remove 2 screws
3. Remove 2 tabs to remove inverter
WARNING: Make sure put back grounding screw when re-
assemble
21
NN-J993
To Next Page
Loading...
