3.1. To set clock
OPERATION SCROLL DISPLAY
1. Plug the power supply cord
into wall outlet.
BEFORE USE REFER TO
OPERATING INSTRUCTIONS
2. Press
Clock
pad.
3. Enter time of day (TOD) by
pressing appropriate
Number
pads.
4. Press
Clock
pad. TOD has
now been resistered into the
digital programmer circuit and will
count up by minutes.
3.2. Time cooking for two stage
OPERATION SCROLL DISPLAY
1. Place a water load in the oven.
2. Press
Power Level
pad
once to set High power.
(1st stage)
3. Set for 5 seconds by
pressing
Number
pads.
5 Sec.= 5
4. Press
Power Level
pad 6
times to set Medium power.
(2nd stage)
5. Set for 1 minute by pressing
Number
pads.
1 Min.= 1
0 0
6. Press
Start
pad.
7. When 1st stage cooking time
has elapsed. Oven beeps twice
and automatically switches to 2nd
stage cooking.
8. When 2nd stage cooking time
has elapsed, oven beeps 5 times
and shuts off.
Time of day or colon if set appears
in the display
3.3. Inverter turbo defrost
OPERATION SCROLL DISPLAY
1. Press
Inverter Turbo Defrost
Pad.
2. Set the weight for 1 lb by
pressing
Number
pads.
1 Ib= 1
0
3. Press
Start
pad.
4. Press
Stop/Reset
Pad
twice.Oven shuts off.
Time of day or colon if set appears
in the display
3.4. Auto Brown Cook (Example to
cook 6 oz Pizza)
OPERATION SCROLL DISPLAY
1. Place brown dish on glass
tray, and press
Preheat
pad.
2. Press
Start
pad. Time in the display window will
count down.
3. When preheat time has
elapsed, a long beep will be
heard every 11 seconds for a
time frame of 3 minutes.
Time of day or colon if set appears
in the display.
4. Open the door, and carefully
place food into the brown dish,
then close the door.
5. Press
Pizza
pad once for 6
oz serving.
(select 6, 9, 15oz)
6. Press
Start
pad.
When cooking time has elapsed,
Oven beeps 5 times and shuts
off.
Time of day or colon if set appears
in the display.
3 OPERATION AND DIGITAL PROGRAMMER CIRCUIT
TEST PROCEDURE (NN-G463)
6
NN-G463 / NN-S443 / NN-S423 / NN-S413 / NN-413
To Next Page
Loading...
