12
Installation
Installing the water lter
The water lter is not installed at the time the refrigerator is purchased.
Install the water lter provided with the refrigerator.
1
Remove the drawer of the Vitamin-Safe Zone.
2
Remove the lter panel.
Place your ngers in the cutout at the front of the lter panel, and
remove the lter panel.
Filter panel
1
2
3
Install the water lter and rotate it 90 degrees clockwise.
3
Water lter
4
Push the water lter down, and put the lter panel back in place.
4
Note:
● Run water through the Water dispenser until the water runs clear (15 glass (approx. 3 litre)). This will clean
the water supply system and remove air from the water supply hose.
To Next Page
Loading...
