Installation
10 cm
30 cm
The distance requested for installation
●The top of the refrigerator and the ceiling at least 30 cm.
●The back of the refrigerator and the wall at least 10 cm.
●The sides of the refrigerator and the walls at least 5 cm.
Area around the installed unit
●Do not locate the refrigerator in a humid place as rust
may form and may cause electric leakage.
●Do not locate the refrigerator exposing to direct sunlight
as the heat and sunlight will increase the temperature.
●Do not locate the refrigerator near heat source such
as cooking stove or oven.
●Do not block the openings around the refrigerator.
●The refrigerator must be located in the place where
there is good air circulation.
●In case of placing the refrigerator on an uneven surface, adjust the
adjustable bolt to make the refrigerator stands stably.
Moving or shifting
●When moving or shifting the refrigerator, remove ice cube tray, box ice tray, pan water
evap etc. and check to be sure that there is no water in the refrigerator.
Power cord setting
●To bring power cord for use, pan water evap from left should be lifted up. Then bring the
power cord out and then insert pan water evap into the block by pressing at both the sides.
LED lamp and grounding
●The refrigerator LED lamp, specially designed for this refrigerator, does not function on
individual replacing. If you need replacement, please contact Panasonic Service Center.
●If there is no grounding wiring plug in refrigerator, it should be connected with grounding
connection to prevent electrical hazard from electric leakage.
5 cm
6
To Next Page
Loading...
