32
9 Disassembly and Assembly Instructions
9.1. Display Panel A’ssy (Display and Control Panel)
Before taking any action, please unplug the power supply.
To separate Display Panel A’ssy from the door, insert flat screw driver (picture B) into the small opening on the down side in the mid-
dle of Display Panel A’ssy. Before you do that please protect the door with scotch tape. Carefully lift the screw driver to detach the
Display Panel A’ssy. Be careful not to damage cable with connector.
On the control unit there are two terminal connectors. Right one is for connecting Display Panel A’ssy with power board. Left is for
uploading SW (optional).
NB! Please wear electrostatic discharge wrist band
To Next Page
Loading...
