To set the operation lock
■
To prevent tampering and incorrect operation, you can set operations not to be performed when the buttons
are pressed.
●
If any button is pressed while the operation lock is set,
“
CL
”
is displayed on the notice indicator area.
●
To cancel the setting, perform the procedure above in the same way.
●
In a case of a blackout or the power plug is disconnected, the temperature setting will reset to
“
1
”
of
the three level setting ;
“
1
”
,
“
2
”
and
“
3
”
.
①
Press the button, and then press the button to make
flash.
②
Press the button to confirm “FREEZER.” ( turns on.)
③
Press the button to make flash.
④
Press and hold the button for at least 10 seconds. (A beep sounds.)
⑤
Press the or button to make adjustments.
(Display the desired level and then press the button. A beep sounds and the setting is completed.
After a short time, the indicator turns off.)
Each press of the button increases the setting by one level. Each press of the button decreases
the setting by one level.
In steps
①
-
②
above, set so that flashes instead of , then set.
Perform the same steps as in
③
-
⑤
.
Perform the same steps as in
①
-
④
above.
(To cancel the setting, make turn on during the step
③
.)
Simultaneously press the
and buttons
for at least 3 seconds.
A beep sounds,
“
CL
”
is displayed on the notice
indicator area, and the setting is completed.
(After a short time, the
“
CL
”
indication turns off.)
For the freezer compartment (ECO NAVI does not operate when the temperature is adjusted in detail.)
For the refrigerator compartment
Notice
Setting to suit your preferences