Fridge Compartment
How to use the Water Dispenser
With the Water Dispenser, you can get cold water without opening the refrigerator door.
How to get water
1 Push the lock upward until it touches the top edge.
2 Keep the cup straight and gently push the lever to get water.
Attention
● Before using Water Dispenser, the Water Connection system
must be installed correctly. Refer to the Installation instruction in
Page 10 ~ Page 17 for details.
● In the rst time using, please run through and discard the rst
3 liters (3 qt) of water, stopping intermittently to remove trapped
air in the system. Failure to do this will result inexpressive
dripping from your dispenser.
● It will take about 1 seconds for water getting out when starting
to push the lever. Purpose of this setting is to limit the water
flow out in the case of accidentally touching the level.
● After taking enough water, slowly take the cup out to avoid the
water leaking.
● Use a clean cloth to dry if any water spills out.
● When you need to lock the Water Dispenser, pull the lock
downward until it touches the bottom edge and the red line can
be seen. If it is not necessary to lock the Water Dispenser, skip
this step.
● Water may not cool if dispensing continuously by Water
Dispenser for a period longer than 2 minutes.
Lock
Push the lever
to get water
35
To Next Page
Loading...
