Panasonic NV-F66A - AUDIO DUBBING

'E--,-;=-&-E==
Note that the
original sound on
the
"normal"
(mono)
sound
track will be completely erased during audio dubbing.
Preparation
.Set
the Input Signal Selector to "Line/Audio".
.lnsert
a
video
cassette
with the erasure
prevention
tab
intact.
When a video cassette
is
already
inside the
VTR,
press
the VTR On/Off Switch to
turn it
on.
.Reset
the Tape Counter to
"0:00.00"
.Turn
the TV
set on
and select the video
playback
channel.
.Select
the "normal"
(mono)
sound
track
by
repeatedly
pressing
the Audio Output
Mode Selector
(Remote
Controller)
until the Audio Output Mode Indicators
"Left"
and
"Right"
are no longer
lit.
Press the
Play
Button
(>)
to look for the
point
where
you
want to start the audio dubbing.
Press the Pause/Still Button
(ll)
at the exact
point
where
you
want to
start
the
audio dubbing.
Press lhe Audio Dubbing Button
(the
indicator will light
uo).
Press the Pause/Still Button
(l
l) once again to release
the tape from
pause,
and at
the
same
time start the
operation of the audio source. The audjo dubbing
will
sIan.
To
interrupl the audio dubbing,
press
the Pause/Still
Button.
.The
VTB will
stop
in
the still
playback
mode.
The sound inserted during
audio dubbing
is recorded
on
the
normal sound track. lf the HiFi sound tracks
(STEREO,
LEFT, RIGHT) are
selected,
the
original sound
(before
the
audio dubbing)
will
be heard.
Hi-Fi/Normal Mix Switch
Set this switch to "On", if
you
want both the
"Hi-Fi"
sound
and "normal" sound to be
played
back mixed together,
.The
mjxed sound may not be very clear.
Always set this switch to
"Off", except
when
playing
back
a
tape
on
which the
insert editing or audio dubbing
was
performed.
.Sound
recorded
by using
the
audio dubbing
function
is recorded on the
"normal"
audio track
(always
in
mono).
.Wh€n
a
microphone is
used
for
dubtir€, do not
place
it near
lhe speaker ol
yoUI
Tv lo
prevent
howlinq
fftse
(acouslic
tee&ad<).
.
lf lhe
eras.re
pferrenlirn
tab of fhe cassette
is
missir€, m atrl|o d.ating
can
b€ made.
o
o
o
@
o