Others
40
LSQT1171
Functions cannot be used
simultaneously
Some functions in the movie camera are disabled
or cannot be selected due to its specifications.
The table below shows examples of functions
restricted by conditions.
Before requesting repair
(Problems and solutions)
Power/Body
1: The movie camera power cannot be turned
on.
• Is the battery fully charged? Use a fully
charged battery.
• The battery protection circuit may have
operated. Attach the battery to the AC adaptor
for 5 to 10 seconds. If the movie camera still
cannot be used, the battery is faulty.
• Is the LCD monitor open or the viewfinder
extend?
2: The movie camera power is turned off
automatically.
• If you set [POWER SAVE] to [5 MINUTES] and
do not operate the movie camera for about
5 continuous minutes, the power is
automatically turned off for tape protection and
power conservation. To resume recording, turn
the [OFF/ON] switch to [OFF]. Then turn it to
[ON] again. (
-36-) Also, if you set
[POWER SAVE] to [OFF], the power does not
automatically turn off.
3: The movie camera power does not stay on
long enough.
• Is the battery low? If the remaining battery
power indication is flashing or the message
“LOW BATTERY” is displayed, the battery has
run down. Charge the battery or attach a fully
charged battery. (
-8-)
• Has condensation occurred? When you carry
the movie camera from a cold place into a
warm place, condensation may occur inside it.
If so, the power is turned off automatically,
disabling all operations except for taking
cassettes out. Wait until the condensation
indication disappears. (
-43-)
4: Battery runs down quickly.
• Is the battery fully charged? Charge it with the
AC adaptor. (
-8-)
• Are you using the battery in an extremely cold
place? The battery is affected by ambient
temperature. In cold places, the operating time
of the battery becomes shorter.
• Has the battery worn out? The battery has a
limited life. If the operating time is still too short
even after the battery is fully charged,
depending on the usage, the battery has worn
out and can no longer be used.
Functions Conditions which disable
the functions
≥Image stabilizer ≥When the colour night
view function is used
≥Backlight
compensation
≥When the iris/gain is set
≥When the colour night
view function is used
≥Help mode
≥Blank search
≥Soft skin
≥Recording
check
≥While recording to a tape
≥Colour Night
View
≥While recording to a tape
≥Scene mode ≥When setting the
[AUTO/MANUAL/FOCUS]
switch to [AUTO]
≥When the colour night
view function is used
≥Change of
white balance
≥When digital zoom
(30k or higher) is used
≥When the colour night
view function is used
≥Adjusting the
shutter speed,
iris/gain
≥When the colour night
view function is used
≥When the scene mode is
used
LSQT1171ENG.book 40 ページ ２００７年１月１０日 水曜日 午後１時７分
To Next Page
