20
Finding a Timer-recorded programme for
viewing (Easy Programme Playback)
Allows you to find a timer-recorded programme with One-
touch operation and to play it back easily.
Preparation
Set timer recording for the programme you wish to view.
Operation
1 Press [PROG PLAY] (5).
• As soon as the timer-recorded programme is found,
playback starts automatically.
To Cancel the Easy Programme Playback:
Press [Stop] (9).
Notes:
• The VCR memorises the position at which timer recording is
set to the standby mode by pressing [TIMER (REC)] (19) at
the start point of Easy Programme Playback.
• If you take out the cassette after a timer recording has
finished, Easy Programme Playback function does not work.
Before Requesting Service
Message of On Screen Display
The error message is indicated in brackets [ ].
[PLEASE PUT IN A VIDEO CASSETTE.]
• [REC/OTR] (41) ([REC] (27)) or [TIMER (REC)] (19) has
been pressed without a video cassette inserted.
#Insert a video cassette.
[PLEASE STOP THE TAPE.]
• [TUNER PRESET] has been selected during playback.
#Stop the tape.
[PLEASE SET THE CLOCK.]
• [TIMER (REC)] (19), [GUIDE] (13), [PROG GUIDE] (45),
[PROG/CHECK] (14) or [TIMER CHECK] (44) has been
pressed when the clock is not set.
#Set the clock.
[PLEASE USE A CASSETTE WITH TAB.]
• [REC/OTR] (41) ([REC] (27)) or [TIMER (REC)] (19) has
been pressed with a video cassette without an intact erasure
prevention tab.
#Use a video cassette with an intact erasure prevention
tab.
[NO TIMER RECORDING HAS BEEN SET.]
• [TIMER (REC)] (19) has been pressed with no timer
programmes.
#Set timer recording.
[VCR IS IN THE TIMER STANDBY MODE.]
• [VCR-ON/OFF] (1) has been pressed during the timer
standby mode.
#Press the [TIMER (REC)] (19) to release the VCR from
the timer standby mode.
[CAN NOT FIND PROG PLAY DATA.]
• [PROG PLAY] (5) has been pressed with no programmed
timer recording data.
#Set timer recording.
The VCR will not operate correctly
The symptom description is indicated in brackets [ ].
[The VCR display is not illuminated.]
• The mains lead has not been connected.
#Connect the mains lead to the mains supply.
[The VCR display is illuminated but the VCR will not operate.]
• The VCR is in the timer mode.
#Press the [TIMER (REC)] (19) to operate the VCR
manually.
• Safety devices are operating.
#Disconnect the mains lead and wait for 1 minute.
Reconnect the mains supply and check functions.
• Dew may have formed.
#Do not operate the VCR for 1 hour.
2222
PROG PLAY
NV‑MV40GL.book20ページ２００３年２月２６日 水曜日 午後５時１１分
To Next Page