GENERAL DISTORTIONS
!
Check AC mains connection.
!
Device is set to recording stand-by or timer mode. Quit with TIMER button.
The VCR display is not lit:
The VCR display is lit, the device does
not respond to controls:
Error code «U » or «H »
appears:
!
H : This is indicative of a malfunction. The digits following «H» depend on what state your player is in.
!
Press to put the player into stand-by mode, then briefly unplug and re-attach the AC mains cable.
!
Contact the aftersales service if this does not remove the problem.
Please state the error code displayed by the set.
The picture is disturbed when searching:
!
This is a technical issue and not indicative of a malfunction.
No picture appears on the screen:
!
Check the connections.
!
Verify that the correct video input of the TV set has been selected.
The picture is cut off at its left or right
edge:
!
Check the Video menu's TV Aspect setting on the Setup screen.
!
Check that the player is directly plugged into the TV set's AV output and not to a video cassette recorder
between the two units.
!
Check the Zoom setting.
There is no audio output and the sound
is distorted:
!
Check the connections.
!
Deactivate the Advanced Surround effect.
43
Before requesting service
The remote control unit does not work
properly:
!
Check whether the remote control communicates VCR1 or VCR2 .
!
Check the distance between the RC unit and the appliance (max. 7 metres).
!
Check the batteries in the remote control unit.
!
Point the remote control unit straight at the remote control signal sensor on the front panel.
No messages are output
to the screen:
!
Go to the DVD SETUP screen and set DISPLAY menu option On-screen Messages- to [On].
!
Go to the DVD SETUP screen and change the TV Aspect setting in the Video menu.
!
Go to the VCR menu Others and change the OSD setting.
18
2
39
40
41
18
39
To Next Page
Loading...
