Panasonic NV-VS50EN - Service Mode 3 (Error Code Display)

MODE NAME FUNCTION How to use.
OSD Line Output Mode Checking the EVF
information on the TV
monitor
Push the following keys simultaneously
more
sec.
FOCUS/SET STOP
(SIDE CASE(R)) (TOP
PANEL)
(
CASE
TOP)
SERVICE MODE 1 Remaining Battery A/D value.
/ Safety Device / Capstan/
Cylinder injuctions.
Push the following keys simultaneously
more
sec.
COLOR STOP
(SIDE CASE(R)) (TOP
PANEL)
(
CASE
TOP)
SERVICE MODE 2 Remaining Voltage A/D value.
/ Mechanism position /
Serial key code
After chosing SERVICE MODE 1, push [
DATE
key.
SERVICE MODE 3 ERROR CODE Display After chosing SERVICE MODE 2, push [
DATE
key.
SERVICE MODE 4 PG SHIFTER ADJUSTMENT After chosing SERVICE MODE 3, push [
DATE
key.
NOTE1:
The content of all service modes (service Mode 1 to 4) are the same as previous models.
Please refer to the following Technical Information.
Order number for Technical Information : VMD9512M138
NOTE2:
When an undesirable condition occurs, the power will be turned off except zoom & focus motor
lock condition. (Since this model, “ERROR CODE” is not automatically displayed on the EVF and
LCD monitor, even the CAMERA LEDis not flashed.)
By turning on Service Mode 3, it is possible to check what kind of undesirale condition has
occurred, even after the ERROR CODE has disappeared. Because of The ERROR CODE is
memorized to EEPROM-IC.
3.2. SERVICE MODE 3 (ERROR CODE DISPLAY)
- ERROR CODE appears on counter display position as follows. (See
Fig.1 ).
Fig.1
8