Panasonic Omnivision PV-8451 - Page 13

(Case 1
If the displayed time is correct, press CH A to exit.
• This concludes one time VCR setup.
• See important note at the bottom of this page.
If the displayed time and DST. are not correct...
If you happen to live close to two time zones, the VCR
may have recognized the PBS channel (setting channel)
in the wrong time zone. Please do the following to
correct the situation.
a Make a note of the SETTING:CH number shown on¬
screen and press CH ▲ to exit.
b Delete the setting channel from the VCR channel
memory. (See “To Add or Delete a Channel”
section on page 14.)
c Press ACTION to display the menu.
d Press AT to select “SET CLOCK,” and then
press ► to display the “SET CLOCK” screen.
e Press AT to select “AUTO CLOCK SET," and then
press ► to display the “CLOCK AUTO SET” screen.
f Press CH A to start Clock Auto Set.
• If you use a cable box and have multiple PBS
stations, tune the cable box to a different PBS
station and try auto clock set using the menu.
1/ 4/2000 TUE 12:00PM
DST;ON
SETTING : CH 02
AUTO CLOCK SET
COMPLETED
END : PUSH CH UP KEY
ACTION
SELECT/SET
(* ▼◄► )
keys
CHANNEL UP
AUTO CLOCK SET
IS INCOMPLETE
PUSH ACTION TO SET CLOCK
If the screen CASE2 appears “AUTO CLOCK SET
IS INCOMPLETE” PI 2, auto clock set is not
available in your area. Please set the clock
manually as described below.
a Press ACTION to display the
SET CLOCK screen.
b Press AT and A ► to
select and set the month,
date, year, time, and
DST. (Daylight Saving Time).
-M/— SET CLOCK
1 / -/—
7]\ D ST; ON
HsrWA>!«E)
SELECT:* ▼ KEY
SET ; ► KEY
END :ACT I ON KEY
To Make Corrections,
repeatedly press A ► to move the cursor
to the incorrect entry and make the correction.
C Press ACTION twice to start
the clock and exit this mode.
SET CLOCK
1/ 4/2000 TUE l2iW
DST;ON
1-Mdtwmamn
SET :* ► KEY
START : ACT I ON KEY
IMPORTANT NOTE FOR AUTO
CLOCK SET WHEN USING
CABLE BOX OR DSS RECEIVER
• Auto clock set will be performed when
the VCR is turned off the first time each
day. If you use a cable box and you
want auto clock set to be performed, the
cable box must be left on and tuned to
the PBS channel before the VCR power
is turned off.
• If you use a DSS receiver, it must be
turned off for auto clock set.
• If you use Audio/Video Jack connection
between the VCR and Cable Box or
DSS receiver, you must also connect
the RF coaxial cable in order to use the
auto clock set and channel auto set
features.
13
Getting
Started