Panasonic Omnivision PV-8451 - Page 19

Cancel a Timer Recording:
(Recording is in progress)
Press POWER and then STOP within 10 seconds to
cancel the timer recording.
• The TIMER indicator goes out in the Multi Function Display.
Replace Program Contents:
(Recording is not in progress)
1 Press PROG to display the “SET
PROGRAM” screen.
2 Press AT to select “TIMER
PROGRAM," and then press ► to
display all currently set programs.
3 Press AW and ► to select and
set a program number.
(See page 18.)
4 Press AT and M. ► to select
and set replacement timer
information.
5 Press PROG twice to exit this mode.
Review or Clear Program Contents:
(Recording is not in progress)
1 Press PROG to display the “SET
PROGRAM" screen.
2 Press AT to select “TIMER
PROGRAM,” and then press ► to
display all currently set programs.
3 Press AT to select a program
number.
4 Press ADD/DLT if you want
to clear the program.
5 Press PROG to exit this mode.
VCR Ptm+ PROGRAM
P DT START STOP CH SPD
2 8 10: OOP 12: OOP 125 SP
3 10 8 : OOP 9: OOP 10 SP
4 $U 9:OOPIOiOOP l LP
CANCEL:ADD/DLT KEY
SELECT 1-8:a V KEY
ENTER : ► KEY
END :PROG KEY
P DT START STOP CH SPD
□ - : - - - -
2 8 10:OOP1 2 : O OP 125 SP
3 10 8:OOP 9:OOP 10 SP
4 SU 9: OOP 10 : OOP L LP
SELECT 1-8:a V KEY
ENTER : ► KEY
END :PROG KEY
Timer Recording Using VCR Buttons
(Make sure a cassette tape is not inserted in the VCR.)
1 Hold down STOP/EJECT and press REW to enter the Program mode.
2 Press FF or REC/TIME repeatedly or hold down to make selections.
3 Press PLAY to set the item and move on.
• To make corrections, repeatedly press PLAY to move the cursor to the right,
or REW to move to the left to the incorrect entry and make the correction.
4 Press STOP/EJECT and REW together to display program contents
after all items have been entered.
• You cannot clear programs with the VCR buttons.
5 Hold down STOP/EJECT and press REW, (release REW first, and
then release STOP/EJECT) to exit this mode.
6 Insert a cassette with record tab and press POWER off to set the timer.
19
Basic
Operation