Panasonic Omnivision PV-8451 - Advanced Features; Special VCR Features

Special VCR Features
"Important: If the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does not
work when pressed, press the VCR button on the remote and try the button again.
Channel Caption
You can set channel names, i.e.
ABC, CBS, so that when selected,
the channel name and number
appear on-screen for easy
identification. You can go with
preset names {up to 24), or
manually create your own (up to 10).
Note: You will need a list of channels
received in your area and the channel
numbers you receive them on.
Preset Caption
1 Press ACTION* to display the menu.
2 Press AT to select “SET UP CHANNEL,”
and then press ► to display the "SET
UP CHANNEL” screen.
3 Press AT to select “CHANNEL
CAPTION," and then press ► to display
the “CHANNEL CAPTION” screen.
4 Press AT to select “PRESET CAPTION,"
and then press ► to display the
“PRESET CAPTION” screen.
• You can set up to twenty-four channel captions.
If you want to set a station name other than
these, go to the “Manual Caption" section below.
5 Press ► to move the shaded area
to the right side.
Then, press AT to change the memorized
channel number to match the caption.
Next, press A to set the memorized
channel number.
Now, press AT to continue.
Repeat step 5 until the
Caption List is complete.
To Make Corrections
Press AT and ► to select the memorized channel number.
Then, press AT to change, or ADD/DLT to delete the channel number.
6 Press ACTION four times to exit this mode and
return to the normal screen.
Manual Caption
3 F ollow steps 1 -3 in the above section.
b In step 4, press AT
to select “MANUAL
CAPTION,” and then
press ► to display the
“MANUAL CAPTION”
screen.
C Press AT to select
“CH NUMBER,” and
then press ► to move
the shaded area to the
right.
• Channels already set in the “Preset Caption"
section and channels deleted from Channel
Memory are not displayed.
• You can set a total of ten channel captions with
up to four characters each.
20
d Press AT to select,
and then press ► to
enter each character of
the caption.
• Characters will change in
the following order.
i—. ► Z -*-BLANK-*- ► &—,
1 - 9 + . 2 •*-!<*- 1
Now, press 4 repeatedly to move the
cursor back to CH NUMBER.
Repeat steps “c” and “d” as desired.
To Make Corrections, repeatedly press ► to move
the cursor to the right, or M to move to the left to the
incorrect entry and make the correction.
To Clear the Caption, press ADD/DLT.
0 Press ACTION four times to exit this mode
and return to the normal screen.